Ring Pro2 Doorbell 90 degree Swivel Adjustable Mount

The swiveling mount can rotate in just about any direction from 15 to 90 degrees. Fits Ring Pro 2 - the pro version can be purchased in a different listing.

Mount and Rotate in any direction. Used when wall for doorbell is 90 degrees from the door and walkway.

Fits this model doorbell found on Amazon. -- Only fits this exact one. Send me message if you have a question about your model, I can let you know how to tell the difference.

Must use the included screws to mount the doorbell to my bracket

Instructions:

1 remove the set screw on the base so the unit rotated freely

2 route the wires through the base and screw the base in the wall

3. Use the set screws to secure a position of where the doorbell will likely go

4. Wire the doorbell

5 screw the doorbell in lot the bracket

6 Turn in doorbell and adjust angle and lock in the set screws

7. If necessary superglue can also be used in the ball joint to prevent any movement

Only fits Ring Pro 2 or original Pro l - Doorbell not included

Everything is printed with high quality PETG

Swivel has a hole to allow wires to pass through the back. Screws are included to mount and secure the perfect angle so It doesn’t move when bell is pressed.

SEE RING MODEL PICTURE TO DETERMINE IF YOU ARE ORDERING THE CORRECT MODEL, if you order wrong model there will be fees to exchange.

****The 15/90 degrees is relative, and it might be slightly less, but this listing provides a doorbell bracket that can work in the 90 degree position relative to the wall. Actual angle can vary depending on the position of the bracket .

****While 3D printing provides really good production quality parts, there are often imperfections that may be found on the prints. These do not impair the function and rarely affect the aesthetics. But if your not happy with the quality, please text, email, or message me before leaving a review.